Periodic maintenance and adjustment
7-29
7
3. Fully charge the battery before in-
stallation. NOTICE: When install-
ing the battery, be sure to turn
the main switch off, then con-
nect the positive lead before
connecting the negative lead.
[ECA16842]
4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals.
ECA16531
Always keep the battery charged.
Storing a discharged battery can
cause permanent battery damage.
EAU23464
Replacing the fuse
The fuse holder is located beside the
battery compartment behind panel A.
(See page 7-7.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to “OFF” and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
avoid causing extensive dam-
age to the electrical system and
possibly a fire.
[EWA15132]
3. Turn the key to “ON” and turn on
the electrical circuits to check if
the devices operate.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
1. Main fuse
2. Signaling system fuse
3. Light fuse
Specified fuses:
Main fuse:
15.0 A
Light fuse:
7.5 A
Signaling system fuse:
7.5 A
UB6FE2E0.book Page 29 Tuesday, June 8, 2021 1:58 PM
To Next Page
Loading...
