EasyManua.ls Logo

Yamaha FINN - Why Yamalube

Yamaha FINN
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Periodic maintenance and adjustment
7-12
7
TIP
Make sure the O-rings are properly
seated.
7. Install the oil filter element cover
and tighten the bolts.
8. Install the engine oil drain bolt with
a new gasket and tighten the bolt.
9. Refill the crankcase with the spec-
ified amount of engine oil, and
then install the oil filler cap.
NOTICE
ECA10441
After changing the engine oil, be
sure to check the oil pressure as de-
scribed below.
10. Remove the bleed bolt, start the
engine and keep it idling until oil
flows out, then install the bleed
bolt.
TIP
If no oil comes out after one to two
minutes, stop the engine. Consult your
Yamaha dealer for inspection before
riding the vehicle again.
11. After checking the oil pressure,
tighten the bleed bolt.
12. Start the engine and let it idle for
several minutes. Check for oil
leakage.
13. Turn the engine off, and check the
oil level one last time.
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
EAU85450
Why Yamalube
YAMALUBE oil is a Genuine YAMAHA
Part born of the engineers’ passion
and belief that engine oil is an impor-
tant liquid engine component. We form
teams of specialists in the fields of me-
chanical engineering, chemistry, elec-
tronics and track testing, and have
them develop the engine together with
the oil it will use. Yamalube oils take full
advantage of the base oil’s qualities
and blend in the ideal balance of addi-
tives to make sure the final oil clears
our performance standards. Thus,
Yamalube mineral, semisynthetic and
synthetic oils have their own distinct
characters and value. Yamaha’s expe-
rience gained over many years of re-
search and development into oil since
the 1960’s helps make Yamalube the
best choice for your Yamaha engine.
Tightening torque:
Oil filter element cover bolt:
10 N·m (1.0 kgf·m, 7.4 lb·ft)
Tightening torque:
Engine oil drain bolt:
20 N·m (2.0 kgf·m, 15 lb·ft)
Tightening torque:
Bleed bolt:
7 N·m (0.7 kgf·m, 5.2 lb·ft)
UB6FE2E0.book Page 12 Tuesday, June 8, 2021 1:58 PM

Table of Contents

Related product manuals