Yamaha FINN - Replacing an Auxiliary Light Bulb; Replacing a Tail;Brake Light Bulb

Periodic maintenance and adjustment
7-31
7
EAUV0700
Replacing an auxiliary light
bulb
This model is equipped with two auxil-
iary lights. If an auxiliary light bulb
burns out, replace it as follows.
1. Place the vehicle on the center-
stand.
2. Remove the auxiliary light bulb
socket (together with the bulb) by
turning the socket counterclock-
wise.
3. Remove the burnt-out bulb by
pulling it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with
the bulb) by turning it clockwise.
EAUM2611
Replacing a tail/brake light
bulb
1. Remove panel B. (See page 7-7.)
2. Remove the socket (together with
the bulb) by turning it counter-
clockwise.
3. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
4. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
5. Install the socket (together with
the bulb) by turning it clockwise.
6. Install the panel.
UB6FE2E0.book Page 31 Tuesday, June 8, 2021 1:58 PM