Yamaha FINN - Replacing a Front Turn Signal; Light Bulb; Replacing the Rear Turn Signal Light Bulb

Periodic maintenance and adjustment
7-32
7
EAUV0500
Replacing a front turn signal
light bulb
NOTICE
ECA10671
It is advisable to have a Yamaha
dealer perform this job.
1. Place the vehicle on the center-
stand.
2. Remove cowling A. (See page
7-7.)
3. Remove the turn signal light bulb
socket (together with the bulb) by
turning it counterclockwise.
4. Remove the burnt-out bulb by
pulling it out.
5. Insert a new bulb into the socket.
6. Install the socket (together with
the bulb) by turning it clockwise.
7. Install the cowling.
EAUU2052
Replacing the rear turn signal
light bulb
1. Remove panel B. (See page 7-7.)
2. Remove the socket (together with
the bulb) by turning it counter-
clockwise.
3. Remove the burnt out bulb by
pulling it out.
4. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
NOTICE
ECAU0091
If a taillight bulb of different wattage
than recommended is used, it may
cause the battery to discharge or af-
fect the taillight lighting.
1. Turn signal light bulb socket
1
UB6FE2E0.book Page 32 Tuesday, June 8, 2021 1:58 PM