Why is my Yamaha Outboard Motor gauge operating unstably?
If the gauge operates unstably, it's likely that the resistor isn't connected to the ending hubs. Connect the gray 6-pin cap to the ending multi-hubs to resolve this.
Why is the Yamaha FL115A Outboard Motor gauge response poor?
If the gauge response is poor, a market obtainable unit connected to the system may have failed, or the signal volume has exceeded 50% of the capacity. Replace the faulty unit or remove the heavy signal output unit.
Why does my Yamaha FL115A Outboard Motor trim gauge always show fully tilted up?
If the trim gauge always shows the fully tilted-up position, the trim sensor signal isn't being received. Connect the pink lead connectors with each other.
Why doesn't my Yamaha FL115A Outboard Motor boat speed gauge show?
If the boat speed and/or coolant pressure gauge isn't showing, it means the optional sensor hasn't been installed. Install the optional sensor to fix this.
Why Yamaha FL115A Outboard Motor won't start but the starter works?
If your Yamaha Outboard Motor's starter is working but the engine won't start, several factors could be the cause. The fuel tank may be empty, or the fuel could be contaminated or stale; in these cases, fill the tank with clean, fresh fuel. The fuel filter might be clogged, so clean or replace it. Also, ensure the engine stop switch lanyard is attached and the shift lever is in neutral. Inspect the spark plugs; they may be fouled or of an incorrect type, requiring cleaning or replacement with the recommended type. Check and refit the spark plug cap(s) if they are fitted incorrectly. Poor connections or damaged ignition wiring can also prevent starting, so check wires for wear or breaks, tighten loose connections, and replace worn or broken wires. For other potential issues like fuel pump m...
What to do if Yamaha FL115A Outboard Motor engine idles irregularly or stalls?
If your Yamaha Outboard Motor engine idles irregularly or stalls, there are several things you can check. Inspect the spark plugs; they may be fouled or of an incorrect type, requiring cleaning or replacement with the recommended type. Ensure that the fuel tank air vent screw is open. Check for any obstructions in the fuel system, such as a pinched or kinked fuel line. The fuel could be contaminated or stale, so fill the tank with clean, fresh fuel. Also, the fuel filter might be clogged, so clean or replace it. Ensure the motor is in a normal operating position and that the fuel joint connection is correct. Verify that the battery lead is securely connected. If the spark plug gap is incorrect, inspect and adjust it as specified. Check the wires for wear or breaks, tighten all loose connec...
General| Brand | Yamaha |
|---|---|
| Model | FL115A |
| Category | Outboard Motor |
| Language | English |
To Next Page
