Operation
40
4. Open the throttle slightly without shifting
using the neutral throttle lever or free ac-
celerator. You may need to change the
throttle opening slightly depending on en-
gine temperature. After the engine starts,
return the throttle to the original position.
IP:
● On remote controls equipped with a neutral
throttle lever, a good starting point is to lift
the lever just until you feel resistance, then
lift slightly more.
● The neutral throttle lever or free accelerator
can only be used when the remote control
lever is in neutral.
5. Press in and hold the main switch to op-
erate the remote choke system. The re-
mote choke switch automatically returns
to its normal position when you release
your hand. Therefore keep the switch
pressed in.
IP:
● It is not necessary to use the choke when
starting a warm engine.
● Push in the main switch fully, or the remote
choke system will not operate.
6. Turn the main switch to “” (start),
and hold it for a maximum of 5 seconds.
7. Immediately after the engine starts, re-
lease the main switch and allow it to re-
turn to “” (on). NOTICE: Never turn
the main switch to “” (start)
while the engine is running. Do not
keep the starter motor turning for
more than 5 seconds. If the starter mo-
tor is turned continuously for more
than 5 seconds, the battery will be
quickly discharged, thus making it im-
possible to start the engine. The start-
er can also be damaged. If the engine
will not start after 5 seconds of crank-
OFF
ON
ZMU01880
U60R76E0.book Page 40 Monday, April 26, 2010 3:39 PM