Maintenance
66
IP:
If the oil changer is not available, remove the
drain screw while holding a container under
the drain hole. Let the oil drain completely.
Wipe up any spilled oil immediately.
6. Add the correct amount of oil through the
filler hole. Put back the filler cap and the
dipstick. NOTICE: Overfilling the oil
could cause leakage or damage. If the
oil level is above the upper level mark,
drain until the level meets the speci-
fied capacity.
[ECM01850]
7. Leave the outboard motor for 5-10 min-
utes.
8. Remove oil dipstick and wipe it clean.
9. Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
10. Recheck the oil level using the dipstick to
be sure the level falls between the upper
and lower marks. Consult your Yamaha
dealer if the oil level is out of specified lev-
el.
1. Oil changer
1. Drain screw
ZMU06619
1
1. Oil filler cap
Recommended engine oil:
4-stroke outboard motor oil
Engine oil quantity:
0.8 L (0.85 US qt, 0.70 Imp.qt)
1. Lower level mark
2. Oil dipstick
3. Upper level mark
ZMU02082
1
3
2
U60R76E0.book Page 66 Monday, April 26, 2010 3:39 PM
To Next Page
Loading...
