Yamaha FT9.9D - TILT SUPPORT BAR; POWER TILT UNIT; TOP COWLING LOCK LEVER; FLUSHING DEVICE

2-14
GB
EMU00156
TILT SUPPORT BAR
The tilt support bar 1 keeps the outboard
motor in the tilted up position.
403**2
q
301045
q
q
000935
EMU00162
TOP COWLING LOCK LEVER
To remove the engine top cowling, turn
the lock lever. Then lift off the cowling.
When replacing the cowling, check to be
sure it fits properly in the rubber seal.
Then lock the cowling again by moving
the lever upward.
1 Top cowling lock lever
EMU01701
FLUSHING DEVICE
This device 1 is used to clean the cooling
water passages of the motor using a gar-
den hose and tap water.
NOTE:
Refer to “CLEANING COOLING-WATER
PASSAGES” in Chapter 4 for instructions
on usage.
q
w
000615
EMU01348
POWER TILT UNIT
This unit tilts the motor up and down and
is controlled via the power tilt switch.
1 Power tilt unit
2 Power tilt motor
cC
Do not step on or exert pressure on the
power tilt motor. The power tilt unit
could be damaged as a result.
66M-9-77-A0-2 3/5/03 9:38 AM Page 30