b. Spark Plug : Recommended No. (CR7HSA-NGK)
Gap 0.6-0.7 mm
c. Valve Clearance : (Cold condition)
(If required) Inlet 0.08 ~ 0.12 mm
Exhaust 0.10 ~ 0.14 mm
(After matching of the mark on sprocket cam chain with mark on Cylinder
Head Casting and ensuring the Piston at TDC of compression stroke.)
d. Kick Operation : For free Movement
e. Carburetor : • Idle RPM In warmed up condition(1300~1500 RPM)
• Check for Overflow
f. Drive Chain : • Alignment
• Slackness (20 ~ 30 mm)
g. Brake Fluid : • Fluid Level (Refer Page 6-18)
h. Fasteners Specified Torque
(Ft-Lb)
1. Cylinder Head Bolts 14-17
2. Engine Mounting
a) Engine Mounting Front and Stay Front 25-29
b) Stay Engine Front and Frame 25-29
c) Engine Mounting Rear and Frame 25-29
d) Engine Mounting Upper &
Stay Engine Upper 25-29
e) Stay Engine Upper and Frame 25-29
3. Front and Rear Silencer Mounting Nut 9-12
4. Crown Handle Centre Bolt 8-14
5.Starter Motor Mounting Bolts 6-7
PRE-DELIVERY INSPECTION REPORT
10-3
SERVICE2.PMD 8/28/2006, 2:23 PM3
To Next Page
Loading...
