5 En
English
Introduction
1
■ Front panel
1 p (On/Standby)
Turns this Player on/Sets to standby mode.
Pressing and holding this button for approximately 5
seconds forcibly resets this Player (system reset).
2 Disc tray door
3 (Eject)
Opens/Closes the disc tray.
4 USB connector (p. 11)
5 Front panel display
Displays various information for operational status.
6 (Play)
Starts a playback.
7 (Pause)
Pauses a playback.
8 (Stop)
Stops a playback.
– A factory-fitted protective film covers the front panel of this Player. Remove the protective film from the Player
before operating it.
■ Rear panel
1 Power cable
This Player has a captive power cable. Connect it to an
AC outlet after all connections are made (p. 10).
– To prevent risk of electric shock, do not touch the
un-insulated parts of any cables while the power
cable is connected.
2 HDMI terminal (p. 10)
3 USB connector (p. 11)
4 NETWORK terminal (p. 11)
Controls and functions
USB
1 2 43 5 6 7 8
Note
USB
0.5A5V
HDMI
NETWORK
MAINS
Note
To Next Page
Loading...
Need help?
General
