58 Repeat, Cue List & Program Play
MD8—Owner’s Manual
A–B Repeat
A–B Repeat playback allows you to repeatedly play a section of a song. Playback repeats
between the specified A and B points, which can be in separate songs.
1. Press the [PLAY] button to start playback.
2. Press the [A B] button when you hear the beginning of the section
that you want to repeat.
REPEAT A appears on the display. Point A has been entered.
3. Press the [A B] button again when you hear the end of the section
that you want to repeat.
REPEAT B appears on the display. Point B has been entered.
The section between points A and B is played repeatedly.
4. Press the [REPEAT] button to cancel A-B Repeat.
A-B Repeat playback is cancelled automatically when the [STOP] button is pressed.
The specified A and B points are not remembered when A–B Repeat mode is cancelled. To
keep the A-B points active, use the [PAUSE] button instead of the [STOP] button to tem-
porarily stop A-B Repeat playback.
The A and B points are not stored when MD8 is turned off.
Tip: To stop playback at the end of each song, set MIDI Sync to either MTC or MIDI Clock.
A–B Repeat
Play Repeatedly
A Point B Point
Song 1 Song 2 Song 3
To Next Page
Loading...
