Yamaha MFC10 - Program Change Memory Edit

10
Normal Mode
To change and select all digits.
Press [x10] two times.
If the 100's digit value is 1, it will change to
0, if it is 0 it will change to 1. (The 10's digit
flashes indicating input standby.)
Press [1]-[0], to select the 10's digit value.
(The 1's digit flashes indicating input standby.)
Once again, press [1]-[0] to select the 1's digit
value.
• When [x10] is pressed twice, the 100's digit value will
alternate between 1 and 0.
• Attempting to select the number 000, will result in 001
being selected. Also, inputting any value above 128
will result in 128 being selected.
■ Program Change Memory Edit...........................................................
The following 4 types of MIDI data can be transmitted with Program Change Memory.
The transmitting Channel Number and MIDI data can be stored to individual Memory Numbers.
• STATUS
C0 CF
~
C0 Channel 1
C1 Channel 2
C2 Channel 3
C3 Channel 4
C4 Channel 5
C5 Channel 6
C6 Channel 7
C7 Channel 8
C8 Channel 9
C9 Channel 10
CA Channel 11
Cb Channel 12
CC Channel 13
Cd Channel 14
CE Channel 15
CF Channel 16
Cn (n=MIDI channel numbers 1-16) assigns the MIDI channel for voice selection. The
number is shown in hexadecimal.
Example: To change the current Memory Number 048 to
126, press [x10], [X10], [2], [6] in that order.
Two times
048 126
• BANK MSB (Bank Select MSB)
• BANK LSB (Bank Select LSB)
000oFF 127
~,
Bank select numbers are used to access voices other than the 128 voices normally available in
MIDI devices and GM devices. Program change data and bank select data (BANK MSB/
LSB:off, 000-127) must be transmitted together to access these voices.
Refer to the owner's manual of the receiving device for specific information on bank select data.
• DATA/CTRL
001 128
~
Sets program numbers (voice numbers 001-128) for transmission.
Refer to the owner's manual of the receiving device for details on voice assignments.
Refer to a GM voice map for the 128 voice allocations of GM MIDI devices.
• The default settings for each memory (001-128) is as
follows.
STATUS=C0 (Channel Number 1), DATA/CTRL=001-128
(same as the memory number), BANK MSB/MAX=off,
BANK LSB/MIN=off.