12
Normal Mode
Function Memory
Press [FUNCTION], the FUNCTION lamp will light, and Function Memory is enabled.
Function Memory stores and transmits MIDI data such as note on/off, control change, program
change, song select, start, continue, stop, etc., in its memory.
There are 100 (F00-F99) memory allocations in which Function Data can be saved.
• Press [FUNCTION] to enable to Program
Change Memory. (The FUNCTION lamp is off.)
■ Function Memory Control (Transmit) ................................................
Function data is transmitted when a Memory Number is selected using the [1]-[0] and [x10] foot switches. A total
of 100 (F00-F99) memory allocations are available for storing such data.
Example: To change the Memory Number “F84” to “F81”
press the [1] foot switch once.
Example: To change the Memory Number “F23” to “F47”,
press [x10], [4], [7] in that order.
F84
F81
Press one of the [1]-[0] foot switches.
Press the [x10] foot switch. (The 10's digit of
the LED flashes indicating input standby.) Press
[1]-[0], to select the 10's digit value. (The 1's digit
flashes indicating input standby.)
Once again press [1]-[0] to select the 1's digit
value.
To change and select the 1's digit.
To change and select both the 10's and
1's digits.
F23 F47
Select a Memory Number
To Next Page
Loading...
