Yamaha MFC10 - Normal Mode Operation Details; Program Change Memory Management

8
Normal Mode
Both Program Change Memory and Function Memory can be accessed in the Normal
Mode.
Press the [FUNCTION] to switch between Program Change Memory and Function
Memory.
There are 100 memory allocations for Function data
(control change etc.). By selecting a memory
number, its stored function data is transmitted to
external devices via the MIDI OUT terminal.
There are 128 memory allocations for Program
Change data. By selecting a memory number, its
stored program change is transmitted to external
devices via the MIDI OUT terminal.
Function Memory
Program Change Memory
1 Press the [POWER ON/OFF] switch on the rear panel to turn
the power on.
2 Set the [FUNCTION NORMAL—MIX] switch on the rear
panel to the [NORMAL] position.
• Program Change Memory (128 types)
• Function Memory (100 types)
Function lamp is lit.
Function lamp is off.
001 128
~
F00 F99
~
3 Press [FUNCTION] to switch between Program Change
Memory (see page 9) and Function Memory (see page 12).
POWER
ON/ OFF
NORMAL — MIX
FUNCTION