Yamaha P-100 - Bulk protect

Bulk protect
The bulk protect function protects the P-100’s internal settings against incoming system exclusive messages.
When this function is turned on, as is normally the case, the P-100 will not accept any incoming bulk dump or param-
eter change messages. When it is set to bulk (“bul”), the P-100 will accept parameter change messages, but protect
against bulk messages. Finally, when turned off, the P-100 will allow its memory to be overwritten by incoming bulk
dumps and system exclusive messages.
1. Enter MIDI Utility mode.
Press the [PROTECT] button while holding down the [MIDI]
button. The current bulk protect setting will appear in the
display.
2.
Set the desired value.
Use the [DATA ENTRY] slider or the [-l] and [+l] buttons to
switch the setting to the desired value.
3. Exit MIDI Utility mode.
Press the [MIDI] button to exit MIDI Utility mode.
36