Yamaha P-100 - Pitch bend range

Pitch bend range
This setting lets you specify how far the pitch of sounds produced by the P-100 will bend when you roll the [PITCH]
wheel all the way in either direction. The range you set here applies only to the P-100’s internal voices. External tone
generators may interpret pitch bend messages from the P-100 in a different manner, depending on their own internal
settings.
1.
Enter MIDI Utility mode.
Press the [PB] button while holding down the [MIDI] button.
The current pitch bend range setting will appear in the display.
2. Set the desired value.
Use the [DATA ENTRY] slider or the [-l] and [+l] buttons to
select the desired value.
You can set a value from 0 to 12 for the pitch bend range.
The number you select is the number of semitones by which the
[PITCH] wheel will raise or lower the pitch of a note when it is
rolled all the way up or all the way down. Setting a range of 0
will effectively disable the [PITCH] wheel, while a value of 12
will enable the wheel to bend notes up or down an entire octave.
3. Exit MIDI Utility mode.
Press the [MIDI] button to exit MIDI Utility mode.
37