The phrase mode includes 15 phrase “jobs” that perform a variety of important functions. To
access and use the phrase jobs, press the
[JOB] key while in the PHRASE mode. This calls the
phrase job list. You can select any job on the list simply by moving the cursor to the required
job (use the cursor keys or the data dial) and pressing
[ENTER]. You can also move up or
down the list in 1-page steps by using the cursor
and
keys while holding one of the
[SHIFT] keys. An alternative method is to enter the job’s number via the numeric keypad and
press
[ENTER].
Returning to the PHRASE Mode
The
[F6]
function key (“Exit”) can be used to exit from any phrase job, and
then from the job list thereby returning you to the phrase mode. You can also
press the
[F6]
function key (“Exit”) while holding one of the
[SHIFT]
keys to
directly return to the PHRASE mode.
00: Undo/Redo
This job will “undo” any other phrase job, edit, or record function if it is
executed before any other operation is performed. In all cases the affected data
is restored to the state it was in before performing the job, edit, or record
operation. This job will also undo the last undo operation (redo).
The name of the last operation performed will appear on the display (i.e. the
operation which will be “undone”). In the example display, above, a realtime
record operation will be undone.
92
To Next Page
Loading...
Need help?
General
