14: Phrase Name
Allows an original name of up to 8 characters to be assigned to the specified
user phrase.
The phrase number parameter selects the user phrase for which a name is to be
assigned: “001” ... “100”.
Lower-case
Characters
To enter a lower-case character, use the cursor keys to move
the cursor to the position at which a character is to be entered,
then press the micro-keyboard key corresponding to the
character to be entered.
Upper-case
Characters
Symbols
Space
Numbers
Delete
Hold the left
[OCT DOWN]
key (“CAPS”) while pressing the
micro-keyboard key corresponding to the character to be entered.
Hold the left
[OCT UP]
key (“SHIFT”) while entering to enter
the symbols listed above the characters corresponding to each
micro-keyboard key.
The right
[OCT DOWN]
key enters a space
Numbers can be entered via the numeric keypad.
The right [OCT UP] key deletes the character at the cursor
position.
NOTE If a series of asterisks
appears in the phrase name area,
t
he selected phrase contains no
data and a phrase name cannot
be assigned.
When the name has been entered press the
[F6]
key (“Exit”) to return to the
job list, or a mode key to go directly to the selected mode (it is not necessary to
press the
[ENTER]
key to enter the specified name).
103
To Next Page
Loading...
Need help?
General
