After setting the parameters as required press
[ENTER]
to execute the Split
Phrase job. The metronome icon will appear on the display while the data is
being processed, then “Completed” will appear briefly when the job is done.
Press the
[F6]
key (“Exit”) to return to the job list, or a mode key to go directly
to the selected mode.
11: Get Phrase
The Get Phrase job is a
convenient way to
create new phrases by
copying a few appropriate meas-
ures from songs. In fact, it’s
sometimes easier to create
phrases in the SONG mode and
then copy them to the PHRASE
mode using the Get Phrase job,
simply because the SONG
mode’s simultaneous monitoring
capability can make recording
easier.
Copies the data from the specified range of measures in the specified track of a
specified song to the specified phrase.
The
“Song”
parameter selects the source song — i.e. the song from which the
data is to be copied: “01” ... “10”.
The
“TR”
parameter selects the source track — i.e. the track from which
the data is to be copied: “01” ... “16”.
The
“M”
parameters above the upper graphic bar are used to specify the
first measure and last measure of the range to be copied.
The
“Phrase”
parameter specified the user phrase to which the data is to
be copied: “001” ... “100”.
After setting the parameters as required press [ENTER] to execute the Get
Phrase job. The metronome icon will appear on the display while the data is
being processed, then “Completed” will appear briefly when the job is done.
Press the
[F6]
key (“Exit”) to return to the job list, or a mode key to go directly
to the selected mode.
101
To Next Page
Loading...
Need help?
General
