Negative values cause a corresponding decrease in velocity, therby producing
a decrescendo rather than a crescendo. The range of this parameter is from
“-99” through “0” to “+99”.
After setting the parameters as required press
[ENTER]
to execute the Cre-
scendo job. The metronome icon will appear on the display while the data is
being processed, then “Completed” will appear briefly when the job is done.
Press the
[F6]
key (“Exit”) to return to the job list, or a mode key to go directly
to the selected mode.
05: Transpose
Of course, you can
transpose all parts as
required to shift the en-
tire song to a different key, but
the Transpose job is actually
more suited to changing the
pitch of a section of a single
track. This can be done to pro-
duce temporary “modulations”
to another key, or to create har-
mony with another track.
Transposes all notes in the specified part up or down by the specified number
of semitones.
The
“TR”
parameter selects the track to be affected by the Transpose job:
“01” ...
“16” for the sequncer tracks, or “Chd” for the accompaniment chord
track.
The
“M”
parameters above the graphic bar are used to specify the first
measure:beat and last measure:beat of the range to be modified.
The
“Transpose”
parameter determines the amount of transposition in semi-
tone increments. Minus (–) values transpose down while plus (+) values trans-
pose up. the range is from “-99” through “0” to “+99”.
After setting the parameters as required press
[ENTER]
to execute the Trans-
pose job. The metronome icon will appear on the display while the data is
being processed, then “Completed” will appear briefly when the job is done.
Press the
[F6]
key (“Exit”) to return to the job list, or a mode key to go directly
to the selected mode.
40
To Next Page
Loading...
Need help?
General
