Yamaha R-N602 Firmware Update Procedure

Firmware Update Procedure for R-N602
IMPORTANT NOTICE
Follow the instructions carefully and do not attempt any other procedures not specified in the instructions
provided by Yamaha. Improperly updated products may cause improper operation, and any parts or service
required to restore proper operation will not be covered under the Yamaha Limited Warranty.
[ Firmware Update by USB ]
Requirements:
・ USB thumb drive, with enough free space to store the firmware.
(File system with FAT16 or FAT32 format)
・ Firmware file provided by Yamaha.
(Unzip program file and BIN file will appear. Copy the BIN file to the root directory of an USB drive.)
STEP 1 Turn off the unit.
STEP 2 Insert the USB thumb drive on the front panel.
STEP 3 While holding down RETURN on the front panel, press power.
STEP 4 “ADVANCED SETUP” will be shown for seconds.
STEP 5 Rotate SELECT/ENTER to select firmware update mode as shown below.
STEP 6 Press DISPLAY to start the update.
note:
DO NOT interrupt the power or press any buttons during the update.
In case the power is accidentally cut off, the R-N602 will restore original firmware. Perform the
update procedure from STEP 1 again.
Update is completed when “UPDATE SUCCESS”, “PLEASE…”, “POWER OFF!” is
displayed alternately. Then, power off the unit.
UPDATE・・・・・USB
DIMMER

Yamaha R-N602 Specifications

General

Power Output	80 W + 80 W (8 ohms, 20 Hz-20 kHz, 0.04% THD)
Bluetooth	Yes (SBC / AAC)
AirPlay	Yes
Type	Stereo Receiver
Audio Channels	2.0
Impedance	8 ohms
THD	0.04% (20 Hz-20 kHz)
Signal-to-Noise Ratio	100 dB (CD)
DLNA	Yes
DAC	Burr-Brown 192 kHz/24-bit
AM/FM Tuner	Yes
Network Connectivity	Ethernet, Wi-Fi
Streaming Services	Spotify, Pandora, SiriusXM
Inputs	Optical, Coaxial, USB, RCA, Phono
Outputs	Headphone, Subwoofer
Dimensions	435 x 151 x 392 mm
Weight	9.8 kg
Speaker Impedance	4 ohms
Supported Audio Formats	MP3, WMA, MPEG4 AAC, WAV, FLAC, AIFF, ALAC, DSD