What to do if Yamaha Receiver fails to turn on?
If your Yamaha Receiver fails to turn on or enters standby mode shortly after being powered on, consider the following: * Ensure the power cord is firmly connected. * Verify the impedance setting matches your speakers. * Check speaker wire connections for shorts. * If exposed to a strong electric shock, put the unit in standby mode, disconnect the power cord, wait 30 seconds, and reconnect.
General| Channels | 6.1 |
|---|---|
| Signal-to-Noise Ratio | 100 dB |
| Input Impedance | 47 kOhm |
| Input Sensitivity | 200 mV |
| Audio D/A Converter | 24-bit/192 kHz |
| Surround System Class | 6.1 channel |
| Digital Sound Processor (DSP) | Yes |
| Tuner Bands | AM/FM |
| Preset Station Qty | 40 |
| Frequency Response | 10Hz-100kHz |
| Total Harmonic Distortion | 0.06 % |
| Inputs | 4 x Audio |
| Outputs | 1 x Audio (RCA), 1 x Video (Composite) |
| Built-in Decoders | Dolby Digital, DTS |
| Surround Sound Effects | Dolby Pro Logic II |
| Tuning Range | FM: 87.5 - 108 MHz |
| Connector Type | RCA |
| Amplifier Output Details | 85 W (Front), 85 W (Center), 85 W (Surround), 85 W (Surround Back) |
| DSP Presets | 7ch stereo, Concert hall, Disco, Game, Jazz club, Movie, Stadium |
To Next Page
