Yamaha SU10 - Dimensions; Weight; Included accessories

● Troubleshooting ● 69
Problem Possible Cause
RECORDING
Cannot record. • Is LINE IN or MIC INPUT connected correctly?
• Have you selected the correct input source? The
selected source (displayed on third line of the LCD)
must match the actual source — either microphone
or line. If necessary, go to RECORDING or UTIL-
ITY mode and change the Input recording pa-
rameter (see page 34 or 56).
• The Recording Trigger (RecTrg) setting may be
inappropriate. Check, and adjust as necessary.
(RecTrg is a recording parameter and can be set
from either REC or UTIL mode. See page 34 or 56.)
• You can increase recording in any of the follow-
ing ways.
• Reduce the sampling grade. (→ page 33.)
• Set Pitch lower. (→ page 34)
• Use mono recording instead of stereo. (→ page
34)
• Compact all pads. (→ page 52)
• Delete one or more pads. (→ page 53 or 64)
MIDI
• Check that the MIDI channel setting on the SU10
and the external device match. (→ page 56)
• Check the MIDI Note Number settings.
(a) If you have cleared the Note Table, all note num-
ber settings have been deleted. You must reas-
sign note numbers to enable pads to drive and
be driven. (→ pages 45, 57).
(b) Check that note number assignments corre-
spond to notes assignments on the external de-
vice.
(c) Remember that note numbers are different dur-
ing SCALE play. (→ page 20)
• Check the MIDI Device No. setting (the DevNum
parameter in the MIDI utility). (→ page 56)
• If the LCD displays the message Wrong Data!:
There is a problem with the data at the sending
side. Bulk receive is impossible in this case.
• Check that the receiving side is correctly set up,
and has sufficient memory to receive the data.
• The SU10 does not support reception of MSDS
sample dumps.
Recording begins too
soon or too late.
Available recording time
is too low.
SU10 cannot drive (or
be driven by) an exter-
nal device.
Cannot receive bulk
dump.
Cannot send MSDS
sample dump.
Cannot receive MSDS
sample dump.