6-30
PERIODIC MAINTENANCE AND MINOR REPAIR
6
To store the battery
1. If the machine will not be used
for more than one month,
remove the battery, fully charge
it, and then place it in a cool, dry
place.
2. If the battery will be stored for
more than two months, check it
at least once a month and fully
charge it if necessary.
3. Fully charge the battery before
installation.
4. After installation, make sure that
the battery leads are properly
connected to the battery termi-
nals.
EAU00809
Replacing the fuse
The fuse holder is located beside the
battery compartment behind panel B.
(See page 6-6 for panel removal and
installation procedures.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to “OFF” and turn
off all electrical circuits.
2. Remove the blown fuse, and
then install a new fuse of the
specified amperage.
1. Fuse
2. Spare fuse
EC000102
cC
8 Always keep the battery
charged. Storing a discharged
battery can cause permanent
battery damage.
8 To charge a sealed-type (MF)
battery, a special (constant-
voltage) battery charger is
required. Using a conventional
battery charger will damage
the battery. If you do not have
access to a sealed-type (MF)
battery charger, have a
Yamaha dealer charge your
battery.
Specified fuse: 15 A
5GF-9-14 (USA) 4/23/02 2:10 PM Page 69
To Next Page
Loading...
Need help?
General
