8-50
8
ECB00942
Always keep the battery charged. Stor-
ing the battery in a discharged state for
an extended period of time will cause
permanent battery damage.
Do not store the battery in an excessive-
ly cold or warm place [below freezing or
above 30 °C (90 °F)].
To install the battery
Be sure the battery is fully charged.
1. Place the battery in its compartment.
2. Hook the battery bands.
3. Connect the positive battery lead by in-
stalling its bolt and cover, then connect
the negative battery lead. NOTICE:
When installing the battery, the main
switch must be off, and the positive
lead must be connected before the
negative lead.
[ECB01111]
4. Install the air intake duct panel by install-
ing the quick fastener screws.
5. Install the hood.
Make sure the battery leads are installed as
shown.
Fully charge the battery before installing it.
1. Positive battery lead (red)
2. Battery band
3. Negative battery lead (black)
UB3D7AE0.book Page 50 Tuesday, November 7, 2017 9:38 AM
To Next Page
Loading...
Need help?
General
