Yamaha XMAX - Starting the Engine

0QFSBUJPOBOEJNQPSUBOUSJEJOHQPJOUT
7-2

EAU78231
4UBSUJOHUIFFOHJOF
NOTICE
ECA10251
4FFQBHFGPSFOHJOFCSFBLJOJO
TUSVDUJPOTQSJPSUPPQFSBUJOHUIFWF
IJDMFGPSUIFãSTUUJNF
In order for the ignition circuit cut-off
system to enable starting, the side-
stand must be up. (See page 5-24.)
1. Turn the main switch on and make
sure that the stop/run/start switch
is set to “ ”.
The following warning lights and
indicator lights should come on for
a few seconds, then go off.
Engine trouble warning light
Traction control system indi-
cator light
Smart key system indicator
light
5*1
The ABS warning light should come on
and stay on until the vehicle reaches a
traveling speed of 10 km/h (6 mi/h) or
higher.
NOTICE
ECA22510
*G B XBSOJOH PS JOEJDBUPS MJHIU EPFT
OPU XPSL BT EFTDSJCFE BCPWF TFF
QBHF  GPS UIF DPSSFTQPOEJOH
XBSOJOH BOE JOEJDBUPS MJHIU DJSDVJU
DIFDL
2. Close the throttle.
3. While applying the front or rear
brake, push the “ ” side of the
stop/run/start switch. Release it
when the engine starts.
5*1
If the engine does not start, release the
start switch after 5 seconds. Before
pressing the start switch again, wait 10
seconds to allow battery voltage to re-
store.
NOTICE
ECA11043
'PSNBYJNVNFOHJOFMJGFOFWFSBD
DFMFSBUF IBSE XIFO UIF FOHJOF JT
DPME
EAU45093
4UBSUJOHPGG
1. While pulling the rear brake lever
with your left hand and holding the
grab bar with your right hand,
push the scooter off the center-
stand.
2. Sit astride the seat, and then ad-
just the rear view mirrors.
3. Switch the turn signals on.
4. Check for oncoming trafc, and
then slowly turn the throttle grip
(on the right) in order to take off.
5. Switch the turn signals off.
1. Grab bar
1