Yamaha XMAX - Starting the Engine

*OTUSVNFOUBOEDPOUSPMGVODUJPOT
5-11

EAU54201
%JNNFS1BTTTXJUDI i  1"44w
Set this switch to “ ” for the high
beam and to “ ” for the low beam.
To ash the high beam, push the pass
side “PASS” of the switch while the
headlights are on low beam.
EAU12461
5VSOTJHOBMTXJUDI i  w
To signal a right-hand turn, push this
switch to “ ”. To signal a left-hand
turn, push this switch to “ ”. When
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to
the center position.
EAU12501
)PSOTXJUDI i w
Press this switch to sound the horn.
EAU54212
4UPQ3VO4UBSUTXJUDI i   w
To crank the engine with the starter,
set this switch to “ ”, and then push
the switch down towards “ ”. See
page 6-2 for starting instructions prior
to starting the engine.
Set this switch to “ ” to stop the en-
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
EAU78190
)B[BSETXJUDI i w
With the main switch in the “ON”
or “ ” position, use this switch to turn
on the hazard lights (simultaneous
ashing of all turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a trafc hazard.
NOTICE
ECA10062
%POPUVTFUIFIB[BSEMJHIUTGPSBO
FYUFOEFEMFOHUIPGUJNFXJUIUIFFO
HJOFOPUSVOOJOHPUIFSXJTFUIFCBU
UFSZNBZEJTDIBSHF
EAU78491
i53*1*/'0wTXJUDI
This switch is used to make setting and
display changes in the multi-function
meter unit. See page 5-3 for more in-
formation.
To use the “TRIP” switch, move the
“TRIP/INFO” switch in direction (a). To
use the “INFO” switch, move the
“TRIP/INFO” switch in direction (b).
1. “TRIP/INFO” switch
1
(b)(a)