– 9 –
9. Air Funnel Set A (MGC-021008-10)
Installation
1. Installing the Plate
Secure the plate onto the throttle body.
As shown, secure the plate only at two positions below, using the supplied screws (25 mm
long).
2. Installing the Supports
Install the supports onto the levers.
Make sure to use the STD bush in the support hole.
*Use the lever and bushing intended for a STD machine.
Parts List
No. PART No. PART NAMEQ’TY REMARKS
1 PLATE L1
2 PLATE R1
3 PRIMARY FUNNEL 4 L=55 mm
4SUPPORT L 1
5SUPPORT R 1
6SHAFT ASSY. 1 Short type
7SECONDARY FUNNEL1L=60 mm
To Next Page
Loading...
