Yamaha YZF-R1 - Wire Harness Set (14 B-F2590-70)

– 60 –
33. Wire Harness Set (14B-F2590-70)
This wire harness is weight-saved by doing away with connecting wires for lights.
NOTICE
x Remove the coupler of the main switch before starting assembling work.
x Do not remove the AC generator but leave it to function. Use on the battery alone will
make the machine unable to run in a short time.
x The wire harness will not function if it is not assembled with the ECU (14B-8591A-70,
71, 72) of the kit.
TIP
x If the wire harness is installed from the kit, the STD D-MODE (drive mode) will not
function.
x If the E-SD (STD steering damper) is not used, removing its coupler will pose no
problem.
Parts List
No. PART No. PART NAMEQ'TY REMARKS
114B-82590-70 WIRE HARNESS ASSY. 1
* 25GF-83976-00 SW., HANDLE 1 1 PIT ROAD LIMITER
3 14B-83976-70 SW., HANDLE 1 1 Map select
42C0-82509-70 WIRE, SUB-LEAD 1
54C8-82188-70 RESISTOR ASSY. 1 Finished with joint in
Wire Harness.
6 14B-2128A-70 BRKT., REGULATOR 1 1
* 7 90480-13003 G
ROMMET 2
* 8 90560-06201 SPACER 2
* 990111-06051 BOLT, HEX. SOCKET BUTTON2
10 14B-2161F-70 BRKT., 5 1
11 14B-2161E-70 BRKT., 4 1
*12 90480-12237 GROMMET 4
*13 90387-06023 COLLAR 4
*14 90338-06018 PLUG3
*15 120-82131-00 BAND,
BATTERY 1
*1690110-06172 BOLT, HEX. SOCKET 3
*17 92902-06200 WASHER, PLAIN3
*1890110-06219BOLT, HEX. SOCKET 4