– 32 –
2-2 Installing Chassis Parts
19. Oil Catcher Tank Set (14B-C1707-70)
The oil catcher tank is available to meet the racing regulations.
The capacity of this tank is 550cc.
Installation
1. Remove the coolant reservoir from the chassis.
2. Remove from the chassis the breather hose that is connected to the air filter case from the
crankcase.
3. Install the oil catcher tank and breather hose from the kit as shown.
(Install at the same positions where the coolant reservoir were removed.)
Change the clip direction so it does not contact the wire harness.
Parts List
No. PART No. PART NAMEQ'TY REMARKS
114B-21707-70 OIL TANK COMP. 1
* 2 90467-18172 CLIP 4
3 14B-15373-70 PIPE, BREATHER1
4 14B-15393-70 PIPE, BREATHER 2 1
* 5 90480-11006 GROMMET 2
* 6 90387-062N2 COLLAR 2
* 790111-06051 BOLT, HEX. SOCKET BUTTON2
* 8 92907-06200 WAS
HER, PLAIN2
To Next Page
Loading...
