Yamaha YZFR1W 2007 User Manual

CRANKSHAFT
5-80
• If they are not flush with each other,
remove the connecting rod bolt and big
end bearing and restart from step “9”. In
this case, make sure to replace the con-
necting rod bolt.
CAUTION:
ECA14680
• Do not use a torque wrench to tighten the
bolt to the specified angle.
• Tighten the bolt until it is at the specified
angles.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS4C81016
CHECKING THE CRANKSHAFT
1. Measure:
• Crankshaft runout
Out of specification → Replace the crank-
shaft.
2. Check:
• Crankshaft journal surfaces
• Crankshaft pin surfaces
• Bearing surfaces
Scratches/wear → Replace the crankshaft.
EAS4C81017
CHECKING THE CRANKSHAFT DRIVE
SPROCKET
1. Check:
• Crankshaft drive sprocket “1”
Cracks/damage/wear → Replace the
defective part(s).
EAS4C81018
CHECKING THE CRANKSHAFT JOURNAL
BEARINGS
1. Measure:
• Crankshaft-journal-to-crankshaft-journal
bearing clearance
Out of specification → Replace the crank-
shaft journal bearings.
CAUTION:
ECA4C81011
Do not interchange the crankshaft journal
bearings. To obtain the correct crankshaft-
journal-to-crankshaft-journal bearing clear-
ance and prevent engine damage, the
crankshaft journal bearings must be
installed in their original positions.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Clean the crankshaft journal bearings,
crankshaft journals, and bearing portions of
the crankcase.
b. Place the upper crankcase upside down on
a bench.
c. Install the crankshaft journal upper bear-
ings “1” and the crankshaft into the upper
crankcase.
NOTE:
Align the projections “a” on the crankshaft jour-
nal upper bearings with the notches “b” in the
upper crankcase.
Crankshaft runout
Less than 0.03 mm (0.0012 in)
Crankshaft-journal-to-crank-
shaft-journal bearing clearance
0.014-0.037 mm
(0.0006-0.0015 in)
Limit
0.10 mm (0.0039 in)

Yamaha YZFR1W 2007 Specifications

General

Brand	Yamaha
Model	YZFR1W 2007
Category	Motorcycle
Language	English