Yanmar 2GM20(F)(V)(C) - Supply Clutch Lube Oil; Supply Cooling Water; Marine Gear Oil Capacity

3. Operation
I
<D Filler port
® Bonnet
® Dipstick
@ Upper limit
@ Lower lim it
3.2.3 Supply Cl ut ch Lube Oil
1 . Remove the filler port cap at the top of
the bonnet, and fill with marine gear-
clut
ch- lu be oil.
2. Fi ll with all to the upper limit on the
dlpstick.
Insert the dipstick fully to
check the level.
3. Tighten the filler port cap securely by
hand.
M
arine gear o il capacity
KM2P
KM3V
KM3P
<D Oil filler port cap
0.3 I
0.8 I
0.35 I
G) Upper lim1Vlower limit
@Dipst i ck
3.2.4 Supply Cooling Wat er (For Fresh
Wat er Cooling Type Only )
Supply cooling water according to the
following procedures.
Be sure to add
antirust or antifreeze to the cooling wa ter.
1. Be sure
to close the 3 water drain
cocks (See illustration right).
Note: The water drain cocks are opened
before shipping from the
plant.
, ~ . I
--:::::::~~~- - Wat er drain co~
<D Fresh water cooler G) Exhaust manifo ld
2. Remove the filler cap of the fresh water
cooler by turning the cap counterclock-
wise
1/3 of a turn.
<D Filler cap
@Den ts
Ci) Fresh water cooler
@ Notches
23