3. Operation
Manual
Operation
(Seawater
Cooling
Only)
1. Open the Kingston cock.
2. Open the fuel tank cock.
3. Set the remote control lever in
NEUTRAL
4.
Pull out the decompression lever.
5. Put the starter handle on the starter
shaft, align the groove and pin, and
turn by hand. When you begin turning,
you
will hear the sound
of
fuel being
injected.
6.
Turn the handle vigorously. When
the
rotation is rapid, return the decom-
pression lever
to
original position. The
engine starts.
7.
Remove the starter handle from the
starter shaft.
Q)
Decomp. lever @ Drive @ Decompression
28
Ma
nua
l
start
pos
i
ti
on
(2)
Restarting
After
Starting
Failure
Before pushing the start button again, be
sure
to
confirm that the engine has
sto
pped completel
y.
If the engine is
restarted while the engine
still has not
stopped, the pinion gear
of
the starter
motor
will be damaged.
El
ectric
Operation
~~
•
rl.
••
::.,;
Do
not
hold
the
start
button
on
for
more
than
15
seconds
at
a
time
.
If
the
engine
does
not
start
the
first
time
,
wait
for
about
15
seconds
before
trying
again
.
After
the
engi
ne has
started,
do
not
turn
the
key
off
.
(It
shou
ld
remain ON.)
Alarm
devices
will
not
work
when
the
key
is
OFF.
(3)
Air
Venting
of
the
Fuel System
After
Starting
Failure
If
the engine only idles and
won't
start a
ft
er
several attempts, there may be air in the
fuel system.
If
air is in the fuel system, fuel
cannot reach the fuel injection pump. Vent
the air in the system according
to
the
following procedures.
To Next Page
Loading...
