3. Operation
<D
(j) Decomp. lever
@ Drive
-
Electric Operation
® Decomp. lever
@ Compression
Manual
start
pos
i
ti
on
4.
Turn on battery switch and Insert key
into key switch. Turn the key
to
the ON
position.
5.
Pul the stop knob continuously while
cranking.
6.
When the start button is pushed, the
engine
will begin cranking. Continue
cranking for about 5 seconds, and
check for abnormal noise during that
time.
(If you remove your hand from the
stop knob while cranking, the engine
will start. Pull continuously.)
3.2.6
Check
and Resupply Lube Oil and
Cooling Water
When engine oil. clutch
oil,
or
cooling
water is supplied for the first time
or
when
they must be replaced, conduct a
trial
operation of the engine for about 5
minutes and check the quantity of
lube oil
and cooling water. The
trial engine
operation
will send the lube oil and cooling
water
to
the
parts,
so
the lube oil and
cooling water
levels will drop. Check and
resupply
as
necessary.
1.
Supplying engine lube oil
(See
3.2.2)
2.
Supplying marine gear lube oil
(See
3.2.3)
3.
Supplying cooling water (See 3.2.4)
3.3 Operating
your
engine
A.
WARNING
To
prevent exhaust gas poisoning, ensure
good ventilation during operation.
Install
ventilation windows, ports or ventilators
in
the engine room.
Never touch
or
allow your clothes
to
touch
the moving parts of the engine during
operation.
If the front drive shaft, V-belt,
propeller shaft, etc. catches your body or
clothes, serious injury may result. Check
that no
tools, cloth, etc. are left on or
around the engine.
A CAUTION
The engine
Is
very hot during operation
and immediately after stopping, especially
the exhaust manifold and the exhaust
pipe. Avoid burns! Never touch or
allow
your clothes
to
touch any part
of
the
engine.
25
To Next Page
Loading...
Need help?
General
