Yanmar 2GM20(F)(V)(C) User Manual

2. Product explanation
2.1 USE, DRIVING SYSTEM , ETC .
The engine
is equipped with marine gear, connect the marine gear output shaft to the
propeller shaft.
In order to obtain full performance from your engine, it is imperative that you check the
size and structure of the hull and use a propeller of the appropriate size.
The engine
must be installed correctly with safe cooling water and exhaust piping and
electrical wiring. The PTO work should be easy to use for onboard equipment.
To handle the drive equipment , driven systems (including the propeller) and other on board
equipment,be sure to observe the instructions and cautions given in the operation
manuals
supplied by the shipyard and equipment manufacturers.
The laws
of some countries may require hull and engine Inspections, depending on the
use, size
and cruising area of the boat.
The installation, fitting and surveying of this engine all require specialized know ledge and
engineering skills.
Consult Yanmar's local subsidiary in your region or your distributor or
dealer .
A WARNING
Never modify this product or release the limit devices (which limit engine
speed. fuel injection
quantity , etc.). Modification will impair the safety and
performance of the product and functions and shorten the product l if e.
Please note that any troubles arising from modification of the product will no t
be covered by our warranty.
DETAIL OF NAME PLATE
The name plate shown below is attached
to the engine. Check the engine's model,
output, rpm and serial number on the
name plate.
MODEL
CONT.RAT
IN G kW
rpm
MAX .OUT PUT kW
rpm
ENGINE NO.
YliUfMA8 D~DHI.-E
8
The name plate shown below is
described in the marine gear. Check the
marine
gear's model, gear ratio, oil used,
oil quantity and serial number.
v
MOD EL KM
__ ,
GEAR RATIO
OIL
SAE2 0IJo HD
OIL QTY.
LTR .
NO .
KIIIIZAICI
~
..)
OSAKA JAP AN

Yanmar 2GM20(F)(V)(C) Specifications

General

Brand	Yanmar
Model	2GM20(F)(V)(C)
Category	Engine
Language	English