EasyManua.ls Logo

Yanmar SD25 - Medium-Interval Maintenance

Yanmar SD25
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PERIODIC MAINTENANCE
34 SD25 Operation Manual
Perform the following maintenance every
250 hours of operation.
• Inspecting and replacing the clutch
shifter
■ Inspecting and replacing the
clutch shifter
See your authorized Yanmar dealer or
distributor for procedure.
Perform the following maintenance every
year of operation.
• Cleaning cooling water suction hole
• Inspecting remote control device
• Repairing case coating
• Inspecting rubber diaphragm seal
ring
• Inspecting seal sensor
• Inspecting and/or replacing the
flexible mount
■ Cleaning cooling water suction
hole
See Removing Deposits from the Lower
Gear Case on page 31.
■ Inspecting remote control device
See Remote Control Device Check on
page 24.
■ Repairing case coating
See Repairing Damaged Coating on
page 31.
■ Inspecting rubber diaphragm
seal ring
Rubber diaphragms (A) and (B)
The rubber diaphragms (A) and (B) of the
Sail-Drive are important parts for the hull
and crew safety. Since rubber
degenerates during use, be sure to inspect
them every two years. The vessel must be
lifted onto a block for this procedure. To
replace, consult your Yanmar Marine
dealer.
Every 250 Hours of Operation Every Year
SD25_OPM.book 34 ページ 2014年6月27日 金曜日 午後5時29分