Yanmar SD25 - Long-Interval Maintenance

PERIODIC MAINTENANCE
SD25 Operation Manual 35
12/05
■ Inspecting seal sensor
See (Figure 6) on page 21. See your
authorized Yanmar Marine dealer or
distributor for inspection procedure.
■ Inspecting and/or replacing the
flexible mount
Replace if clearance is less than 1 mm
(1, Figure 4). See your authorized Yanmar
Marine dealer or distributor for procedure.
Figure 4
Perform the following maintenance every
2000 hours of operation.
• Replacing the flexible mount
■ Replacing the flexible mount
See your authorized Yanmar dealer or
distributor for procedure. Flexible Mount
must be replaced every 2000 hours.
1
K0005449
Every 2000 Hours of Operation
SD25_OPM.book 35 ページ ２０１４年６月２７日 金曜日 午後５時２９分