Yanmar SD60 - Oil Change from Engine Room

PERIODIC MAINTENANCE
26 SD60 Operation Manual
7. Remove the oil pump fitting and quickly
install the oil plug. Torque 10 N·m.
Add oil at the dipstick hole to reach the
proper level as indicated on the
dipstick.
Figure 10
Oil change procedure from engine room
for easy maintenance/Suction of sail
drive fluid
1. Oil change must be done removing the
plug (1, Figure 11) from the oil suction
pipe (2, Figure 11).
Suction can be done with hand pump
(4, Figure 12).
2. Push hose of hand pump (4, Figure 12)
through the suction pipe (2, Figure 11)
and suck the fluid off.
3. Un-screw the oil dipstick (3, Figure 11).
4. Add oil. 3L-SAE 15W-40
5. Screw in the oil dipstick (3, Figure 11).
NOTICE
The used oil is to be handled as special
waste that pollute the environment.
For the safe disposal of used oil, take all
the measures required by the relevant
local rules and legislations.
Figure 11
Figure 12
050904-01X00
052171-00X00
3
1
2
052172-00X00
4
SD60_OPM.book 26 ページ ２０１７年１２月８日 金曜日 午後３時６分