(2)
When using new bevel gars,
i) Insert shims [two sizes available: 0.004, 0.012 in (0.1, 0.3 mm)j between
the bevel gear 14 and
bill bearing 6305 so that the backlash
[Item'
12)of the
bevel gear
14
and king pin bevel gear 28/14 /18/18] is 0.004-0.012 in
(0.1-0.3
mm).
ii) Insert shims [two sizes mailable: 0.004, 0.012 in (0.1, 0.3 mm)] between
the bevel gear 20
1271 and ball bearing 6306 /6305] so that the backlash
(Item 13) of the kingpin bevel gear 28/14 /18/18] and bevelgem 20 /27]
is 0.004-0.012 in (0.1-0.3 mm).
CAUTION:
I) Figures
or the end of gear indicate the number of teeth
2)
Figures in
[
]
indicate those before Serial No. 51 000.
To Next Page
Loading...
