the following manner:
.ij
Insert a 0.331 in
(8.4
mmj blockgauge in place of the friction disc.
iij
Attach the clutch cover
to
the flywheel face and properly tighten
iiij
The height from the face
of
the flywheel to the tip of the release lever should
be measured with a pair of calipers and a
smighr scale.
(21
The clearance referred to in Item 21 above.is adjusfed after the total stroke of the
clutch
pedal and the clutch pedal play have been properly adjusted.
2.
TRANSMISSION AND RELATED ITEMS
The motive power of the engine is transmitted to
the transmission via the clutch.
The Model
YM135(D) and YM155(D) tractors
are capable of being operated in a wide range of
speeds, (six forward speeds and two reverse
speeds), through the combination of its gear shift
lever and. range shift lever. In addition, in con-
junction with
its
speed shifting system, two
operating speeds are available for the power take
off.
A
one-way clutch
is
provided on the connecting
shaft which is an extension of the
P.T.O.
driving
shaft, so that if
a
sudden load
is
applied from the
implement side, this load is completely disen-
gaged from the transmission side
-
another con-
sideration contributing to safer operation.
To Next Page
Loading...
