Yanmar YM135d - Driven Shaft Assembly

2-5 Driven Shaft Assembly
(11) liner 17 x 30 x 1.
[Parts Having
a Serial No. After 51001 j
(3)
Press fit the (2). (12) ball bearings 6303.
(1)
Fit the (3)
circlip 25 to the (1) driven shaft.
NOTES:
a)
It is easy to drop the (11) liner duringassembly
(2) After step 1, with the driven shaft in the
so handle it securely.
transmission gear case, insert the following from
the final. reduction gear case side: (4) collar
25~
b)
Be sure to install the (5). (7) and (9) gears in
32 x 24.5, (5) driven gear 15, (6) collar 25 x 32 x
the conecr direction since they perfom chamfering
29, (7) driven gear 18, (8) collar 25 x 32 x 24.5,
on one side.
(9) driven gear 13, (10) driven gear 26 and the
(51 Driven gear 15
1 Collar 25~32~24.5
Clutch housing ride
Final reduction
1 (71 Drnven gear 18
(8) Collar 25~32~24.5
[Parts Having a Serial No. Before 51000j
x 32 x 15. (8) driven gear 12, (9) driven pear 26.
and
(10) liner 17 x 30 x 1.
(1) With the (1) driven shaft in the transmission
case, insert the following from the final reduction
(2)
Press-fit the (11). (12) ball bearings 6303.
gear case side:
(2) collar 25 x 32 x 20.5, (3)
driven gear 17,
(4) collar 25 x 32 x 30, (5) driven
NOTE: The (10) liner is easily dropped during assem-
gear 21, (6) collar 25 x 32 x 10, (7) collar 21.4
bly so handle it securely.
(41 Collar 25x32~30
Clutch housing
side
Final reduction
0.5V I15 mml
0.39 (10 mml
1.18 (30mml
' (6) Collar 25x32~10
(7) Collar 21.4~32~15