Out
side
(
\\
\
0
Prevent
to
turn
up
when
inserting
(9)
Be sure to apply grease to the inside of the
oil seal lip to prevent damage to the lip. Also
before installing apply grease to both the lip and
the shaft.
n
j10)
Be sure to apply grease to the O-ring and to
the O-ring oil seal, and to the slot, shaft and hole
before installing.
(11)
Press-fit: To prevent deforminy the bushings
and bearings during press fitting be sure to use
ei-
ther a mandrel or an appropriate press fitting tool
for this operation.
(12)
When assembling the bearings do not hit
them directly with a hammer. Use a drive-in tool
and plate as much as possible and hit them with
a hammer if needed.
(13)
When assembling the gear and stepped collar,
be sure to put them in the right direction. Pay spe-
cial attention to the direction of the gear chamber.
(16)
Apply the proper amount of bond to the
packing, and be sure that none gets on the inside
of the case or the surface of the teeth.
It
can
lead to a clogged oil strainer or
its
malfunction.
(17)
Apply bond
to
both sides of the packing.
(18)
The circular ring and circlips sometimes be-
come weak after they have been removed, con-
sequently check them before assembly.
(19)
The following points should be observed
when connecting the "housing.
assembly clutch"
to both the transmission case and the gear case
assembly final reduction:
a)
when the main transmission
is
in the neu-
tral position the P.T.O. transminion
is
in either
1
or
2.
b)
It
is
connected to the P.T.O. shaft when
the latter moves clockwise.
(20)
When assemblying the clutch disc assembly,
six bolts
8
x
20
should be attached after they
have passed through the shaft and main driving.
(14)
Tighten the bolts and nuts to their specified
tightening torque. The screws are made of light
alloy and should not be overtightened.
(21)
When bending the cotter pin downwards,
(15)
Use caution when unpacking, get rid of the
bend
it
completely, along the nut or set pin.
-Id packing, and completely remove any oil that Even when the set pin diameter
is
small, making
.
on the surface with thinner. After
it
has com-
the procedure difficult, bend and set
it
so. that
it
pletely dried apply bond.
does not exceed the washer diameter.
To Next Page
Loading...
