Yard-Man AutoDrive 604 - Steering Assembly

REF.
NO.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
PART
NO.
683-0263
710-0604
=783-0726
783-0727
783-0728
710-0514
711-1291
711-1292
712-0240
712-0241
712-0431
712-0459
712-3004A
717-1550
717-1554
723-0448A
736-0169
736-3084
738-1001
741-0475
741-0656
748-0416
731-1869
731-1904
638-0019
638-0021
638-0020
638-0022
Steering Assembly
RER
DESCRIPTION NO.
Lower Frame Assembly 27
Self-tapping Screw, 5116-18 x .625 28
RH Pivot Support Bmckst 29
LH Pivot Support Bracket 30
Pivot Bar Bracket
Hex Cap Screw, 3/8-16 x 1 (Grade 5) 31
LH Drag Unk 32
RH Drag Link
Jam Nut, 7/16-20 (Grade 2) 33
Hex Nut, 3/8-24 (Grade 2) 34
Flange Lock Nut, 3/8-16 35
Flange Lock Nut, 7/16-20
Flange Lock Nut, 5/16-18 36
Steering Gear, 11/90 Ratio
Steedng Pinion Gear
BallJoint, 7/16-20
LockWasher, 3/8
Flat Washer, .51 x 1,12 x .06
Steering Shaft, .625 OD x 24.4 37
Plastic Bushing, .38 ID
Hex Flange Bearing, 5/8 38
Shoulder Spacer, .38 ID 39
Steering Wheel, .625 Spllne 40
Steering Wheel Cap w/Logo 41
LH Axle Assembly, .625 Diameter 42
LH Axle Assembly, .625 [ .750 Diameter 43
RH Axle Assembly, .625 Diameter 44
RH Axle Assembly, .625 / .750 Diameter 45
PART
NO.
683-0128A
712-0431
714-0470
726-0214
726-0341
736-0162
736-0187
736-0316
736-0285
738-1011
741-0659
741-0660
634-0105A
634-0172
734-0255
734-1731
1741-0487A
741-0706
734-1787A
727-0425A
783-0653
738-1020
736-0331
738-0140
736-0242
710-0643
737-3000
7100525
DESCRIP'nON
Pivot Bar
Flange Lock Nut, 3/8-16
Cotter Pin
Push Cap, 5/8
Push Cap, 3/4
Flat Washer, .64 x 1.0 x .12
Flat Washer, .64 x 1.24 x .06
Flat Washer, .78 x 1.59 x .06
Fiat Washer, .635 x 1.589 x .06
Shoulder Screw, .5 x 2.2, 3/8-16
Flange Bearing, .632 ID x .937 OD
Flange Bearing, .760 ID x .937 OD
Wheel Assembly Complete, 15 x 6 x 6
Rim Only
Air Valve (Not Shown)
Tire Only, Square Shoulder
Plastic Flange (Not Shown)
Plastic Flange w/Fitting (Not Shown)
Hub Cap, Yellow w/Sprig Logo
Spdng Clip (Not Shown)
Steering Support Bracket
Shoulder Screw, .625 x .50, 7/16-20
Bell Washer, .39 x 1.13 x .062
Shoulder Screw, .435 x ,178, 5/16 x .56
Bell Washer, .34 x .872
Hex Bolt, 5/16-18 X 1
Grease Fittting (if so equipped)
Cast Iron Pivot Bar (if so equipped)
NOTE: For painted parts, please refer to
the list of color codes below. Please add
the applicable color code, wherever
needed, to the pad number to order a
replacement part. For instance, if a part
numbered 700-xxxx is painted Yard-Man
Green, the pad number to order would be
700-xxxx-0665.
Yard-Man Green: 0665
Yard-Man Yellow: 0674
Powder Black: 0637
31