How to fix YASKAWA Controller Er-04?
To fix the YASKAWA Controller error Er-04, check the input data, as there might be a resistance fault due to wrong input data. Check the wiring, as Auto tuning might have exceeded the given time frame. Re-enter the data and repeat the Auto-Tuning, as calculated values might be out of range.
What to do if YASKAWA CIMR-VC shows Drive Overload?
If the YASKAWA Controller is showing a drive overload, check the load to ensure it is not too heavy. Also, verify that the drive capacity is sufficient for the load. If there's too much torque at low speed, reduce the load or increase the drive size.
How to troubleshoot YASKAWA CIMR-VC Ground d Fault?
To troubleshoot a ground fault in your YASKAWA Controller, check the output wiring and motor for short circuits or broken insulation. If the cable or motor insulation is damaged, replace the broken parts. Also, if there's excessive stray capacitance at the drive output, try reducing the carrier frequency.
How to resolve YASKAWA Controller l Circuit ult to?
To resolve an l Circuit ult to on the YASKAWA Controller, cycle the drive power supply, as there is a problem in the drive’s control circuit. Initialize the drive. Replace the drive if the fault occurs again.
How to troubleshoot YASKAWA CIMR-VC Controller oPE02?
To troubleshoot the YASKAWA Controller error oPE02, set parameters to the proper values, because parameters were set outside the allowable setting range.
What does YASKAWA Controller End2 mean?
The YASKAWA Controller error End2 means motor iron-core saturation alarm. Check the input data, as calculated core saturation values might be out of range. Check the motor wiring, because incorrect data was entered. Perform Auto-Tuning without load connected.
What to do if YASKAWA CIMR-VC Controller shows Externa l Faults to ?
If your YASKAWA Controller is showing external faults, find out why the device tripped the EF, remove the cause and reset the fault, as an external fault was triggered by an external device via one of the digital inputs S1 to S6. Also, check the functions assigned to the digital inputs, as the digital inputs might be set up incorrectly.
How to troubleshoot YASKAWA CIMR-VC Controller Undervoltage?
If your YASKAWA Controller displays a Controller Undervoltage error, cycle power to the drive. If the fault continues to occur, replace the drive.
How to resolve YASKAWA Controller End3?
To resolve the YASKAWA Controller error End3, check the input data and repeat tuning, because it indicates a rated current alarm.
What causes YASKAWA CIMR-VC Safe D Fa isable ult ?
The YASKAWA Controller Safe Disable fault occurs when the drive output is disabled while only one of the Safe Disable inputs is open. Check the wiring from the upper controller and make sure that both signals are set correctly by the controller. If the signals are correctly set and the alarm persists, consider replacing the drive.
General| Brand | YASKAWA |
|---|---|
| Model | CIMR-VC series |
| Category | Controller |
| Language | English |
To Next Page