To Next PageTo Next PageWhy is my YASKAWA CIMR-VC Controller showing Input Phase Loss?
An Input Phase Loss error on your YASKAWA Controller indicates an input voltage drop or phase imbalance. Check the power supply and ensure that all cables are properly fixed to the correct terminals, as one of the input phases might be lost.
How to fix YASKAWA Controller Er-04?
To fix the YASKAWA Controller error Er-04, check the input data, as there might be a resistance fault due to wrong input data. Check the wiring, as Auto tuning might have exceeded the given time frame. Re-enter the data and repeat the Auto-Tuning, as calculated values might be out of range.
What causes YASKAWA CIMR-VC Safe D Fa isable ult ?
The YASKAWA Controller Safe Disable fault occurs when the drive output is disabled while only one of the Safe Disable inputs is open. Check the wiring from the upper controller and make sure that both signals are set correctly by the controller. If the signals are correctly set and the alarm persists, consider replacing the drive.
How to resolve YASKAWA Controller Er-09?
To resolve the YASKAWA Controller error Er-09, increase the acceleration time C1-01, as the motor did not accelerate for the specified acceleration time. Check the torque limits L7-01 and L7-02.
What does YASKAWA CIMR-VC oPE05 mean?
The YASKAWA Controller error oPE05 means that the run command source (b1-02) or frequency reference source (b1-01) is set to 3 but no option board is installed. Install the required option board. Correct the values set to b1-01 and b1-02, because the frequency reference source is set to pulse input but H6-01 is not 0.
What does YASKAWA Controller End2 mean?
The YASKAWA Controller error End2 means motor iron-core saturation alarm. Check the input data, as calculated core saturation values might be out of range. Check the motor wiring, because incorrect data was entered. Perform Auto-Tuning without load connected.
How to resolve YASKAWA Controller l Circuit ult to?
To resolve an l Circuit ult to on the YASKAWA Controller, cycle the drive power supply, as there is a problem in the drive’s control circuit. Initialize the drive. Replace the drive if the fault occurs again.
What causes YASKAWA CIMR-VC Heat Ove o sink rheat r?
The YASKAWA Controller heatsink can overheat due to several reasons. Check if the surrounding temperature is too high and install cooling devices if necessary. Ensure the cooling fan is working. Clean the heatsink if it's dirty, and make sure there's sufficient airflow around the heatsink.
How to fix YASKAWA Controller t Reset?
To fix a t Reset on the YASKAWA Controller, turn off the Run command and reset the drive, because fault reset was input when a Run command was active.
How to troubleshoot YASKAWA CIMR-VC Ground d Fault?
To troubleshoot a ground fault in your YASKAWA Controller, check the output wiring and motor for short circuits or broken insulation. If the cable or motor insulation is damaged, replace the broken parts. Also, if there's excessive stray capacitance at the drive output, try reducing the carrier frequency.
General| Brand | YASKAWA |
|---|---|
| Model | CIMR-VC series |
| Category | Controller |
| Language | English |
