Mechanical Installation
3
3.7 Installation Procedure
YASKAWA TOEPC71061779E GA800 DRIVE INSTALLATION MANUAL
37
3. Install the drive in the cut opening of the enclosure panel and use screws to safety it to the enclosure panel.
Tighten the screws to a correct tightening torque:
• M5 screws: 1.96 N∙m to 2.53 N∙m (17.35 lbf∙in to 22.39 lbf∙in)
• M12 screws: 31.38 N∙m to 39.23 N∙m (34.70 in∙lb to 43.37 in∙lb)
A - Enclosure panel
B - Gaskets
C - M12 screws
D - M5 screws
Figure 3.27 Install the Drive into the Opening of the Enclosure Panel
To Next Page
Loading...
