4.1 Replace Cooling Fans and Circulation Fans
60
YASKAWA TOEPC71061779E GA800 DRIVE INSTALLATION MANUAL
1. Connect the relay connector between the drive and circulation fan.
A - Circulation fan B - Fan unit base
Figure 4.44 Connect the Relay Connector
2. Align the pin on the fan unit base with the notch on the fan and put the fan in the fan unit base, then use the
screws to attach it.
Tighten the screws to a correct tightening torque:
• 0.98 N∙m to 1.33 N∙m (8.67 lbf∙in to 11.77 lbf∙in)
A - Circulation fan
B - Fan unit base
C - Alignment pin on fan unit base
D - Circulation fan connector
Figure 4.45 Install the Circulation Fan
3. Attach the fan cable through the clamp.
A - Clamp
Figure 4.46 Attach the Fan Cable
4. Put the fan unit into the specified location and slide it to the left, then use screws to attach it to the drive.
Tighten the screws to a correct tightening torque:
• 0.98 N∙m to 1.33 N∙m (8.67 lbf∙in to 11.77 lbf∙in)
To Next Page
Loading...
