YASKAWA HR Series - Page 107

Notes:
l. Timing with operation• setting signal
50msOR MORE
__ MAN [ "1
MCCW(MCW) I
2. When speed select signaI(SP2ND,,SP3RD) is used and speed is changed during operation,
corresponding parameter speed is set.
SEP[EDT (1.ST SPEED),_' i2NDSPEED)_ (3RDSPEED)_((4THSPEED)
MCCW (MCW) 7 [
l _ l (3RI_ SPEED) i(4THSPEED)_
SPEED (2ND SPEED)
Ot _ = t
3. In DG-SWspeed reference, speed varies if the setting is changed while MCW(MCCW)is
turned on since setting data are read-in every 120ms*.
However, do not change DG-SW setting during operation, incorrect data may be read-in.
* Parameter 65 b2 = 0
- 105 -