6.2.3 Signal Operation and Functions (Cont'd)
(b) Manual operation mode
Constant start operation is performed only when manual operation signal (MCWor
MCCW)is turned on. Operation method is set on parameter 15.
(Positon reference method: Station No., DG-SW or command table)
Items Contents
Accel/Decel speed SPEED I / _,--SPEED: FOUR TYPES OF SETTING
METHODS AVAILABLE
speed 1 __a ] a(_ - t
0 t OPERATION [ -
SIGNAL ON ._],
a: ACCELERATION RATE (PARAMETER SETTING)
Bondi t ions MOTORCURRENT (SERVOON.)
CONDUCTION I I
MANUAL OPERATION
MODE MOTOR FORWARD RUNNING
MCCW ON
MCW ON i -- MOTOR REVERSE RUNNING
Station No. Performs positioning at the nearest station in the operating direction after
Re(. Method operation signal is turned OFF.
MCW (OR MCCW) I [
_Parameter [ (STOPPING TARGET POINT_
15] = 0 SPEED I / _\ \IS INDICATED BY NO. 2. }
, \
/
/
\
\
0" (STATION NO.) No.1 No.2 POSITION
Dueto accel/decel rate, the second, nearest station may be selected.
t..
_. DG-SW Stops at a deceleration rate set to parameter after operation signal is
¢_ Re(. Method turned OFF.
_Parameter
153 = 1
CommandTable
Method
_Parameter
153 = 4
-- 104 --
To Next Page
Loading...
