Illl INSTALLATION AND WIRING I
I
10.1 RECEIVING
This motor has been put through severe tests at the factory before shipped. After
unpacking, however, check and see the following.
• Its nameplate ratings meet your requirements.
• It has sustained no damage while in transit.
• The outpu[ shaft should be hand-rotated freely. However, the brake-mounted motor
does not rotate as it is shipped with the shaft locked.
• Fastening bolts and screws are not loose.
If any part of the motor is damaged or lost, immediately notify us giving full
details and nameplate data.
10.2 INSTALLATION
10.2.1 Servomotor
AC Servomotor can be installed either horizontally or vertically.
(1) Before mounting
Wash out anticorrosive paint on shaft extension and flange surface with thinner
I before connecting the motor to the driven machine. See Fig. lO. 1.
ANTICORROSIVE
PAINT
i Fig. 10.1 Anticorrosive
Paint to be Removed
(2) Location
Use the motor under the following conditions.
• Indoors
• Free from corrosive and/or explosive gases or liquids
• Ambient temperature: 0 to +40°C
• Clean and dry
• Accessible for inspection and cleaning
If the AC servomotor is subject to excessive water or oil droplets, protect the
motor with a cover. The motor can withstand a small amount of splashed water or oil.
D
-- 197 --
To Next Page
Loading...
